Mr Mysterium in 3D! [Archive]

Alan Skinner

04-13-2008, 10:14 PM

OK,

We finally finished it. The Mysterium mask in 3D!

http://www.virtualabs.com/RED/Mr_Mysterium.jpg

Modeled in Adesk Inventor and printed in ABS plastic with a Dimension SST printer.

Didn't have time to paint it to match the artwork that Ian did but it will get colored up later.

Here is link to 3D render pass: http://www.virtualabs.com/RED/flyby.mov

Can't wait to see some of you guys in Vegas! Flying out tomorrow.

Alan

Ace

04-14-2008, 02:54 AM

Thats pretty cool! I see the teeth area wall thickness may have given you a bit of drama there.. hope it didnt!

James T Mather

04-14-2008, 03:01 AM

where did you get it printed?

Jeremy Hughes

04-14-2008, 05:35 AM

I like 3D printers. How big is it? It looks great.

Alan Skinner

04-14-2008, 08:12 AM

Thanks for the feedback!

We modeled at 16 inches O.D. for the Blades but our 3D printer (we have one in house) has a working envelope of 8x8x10 inches so we had to scale it down and that is why the surfaces above the eye sockets are a bit thin. We will make some modes to the file but it was all just for fun anyway.

Alan