Adobe Encore: "Encode Failed"

[Tim Morten]

I'm trying to create a regular DVD (not BluRay) of my Red project. Every time I try to build the ISO in Adobe Encore, I get the message "Encode Failed" after it's about 20% of the way through.

Any advice (besides switching platforms :))?

Thanks,
Tim

[Kevin Halverson]

Does this failure only occur when trying to build an ISO? Can Encore 'play' through the point of failure?

If the point of failure is constant, I would suggest building a new time line that begins just after the point of failure. Then try to build a DVD from that point. This might point to a corrupt asset.

[Tim Morten]

Unfortunately, I'm not getting video at all from my R3D project. I managed to get it to transcode a 1080p H.264 stream from Encoder without freezing, but after a few frames, the video goes green. Next I'll try using Encoder to create a single MPEG2 stream, and put that on the timeline instead; hopefully that will solve it.

Best,
Tim