Stuart English
04-21-2009, 10:07 AM
From a (future version of) Operations Guide.
USB-2 Master.
This port permits the camera to operate as the Master camera in a Master / Slave camera pair.
To establish control, plug the square end of a USB-2 cable into the lower USB port of the RED ONE camera to act as a Slave, and the rectangular end of a USB-2 cable into the upper USB port of the RED ONE camera to act as the Master. Then power cycle both cameras. On boot up the two cameras will automatically establish Master / Slave mode.
Once connected using the USB cable, User Interface commands and remote triggers received by the Master camera are transmitted to the Slave camera.
This is a preliminary implementation, but supported commands include -
PROJECT:
TIME BASE
QUALITY
RESOLUTION
SENSOR:
ISO (SENSITIVITY)
COLOR TEMP
SHUTTER MODE
SHUTTER SPEED
SHUTTER SYNCRO
SHUTTER PHASE
TRANSPORT:
RECORD
GPI RECORD TRIGGER
PRE-RECORD
PLAY
FAST FORWARD
FAST REVERSE
NEXT CLIP
PREV CLIP
EXIT
USB-2 Master.
This port permits the camera to operate as the Master camera in a Master / Slave camera pair.
To establish control, plug the square end of a USB-2 cable into the lower USB port of the RED ONE camera to act as a Slave, and the rectangular end of a USB-2 cable into the upper USB port of the RED ONE camera to act as the Master. Then power cycle both cameras. On boot up the two cameras will automatically establish Master / Slave mode.
Once connected using the USB cable, User Interface commands and remote triggers received by the Master camera are transmitted to the Slave camera.
This is a preliminary implementation, but supported commands include -
PROJECT:
TIME BASE
QUALITY
RESOLUTION
SENSOR:
ISO (SENSITIVITY)
COLOR TEMP
SHUTTER MODE
SHUTTER SPEED
SHUTTER SYNCRO
SHUTTER PHASE
TRANSPORT:
RECORD
GPI RECORD TRIGGER
PRE-RECORD
PLAY
FAST FORWARD
FAST REVERSE
NEXT CLIP
PREV CLIP
EXIT