Brent@RED
07-22-2009, 12:40 PM
The latest version of RED ONE beta firmware (Build 20 - v20.0.2) has been released on www.red.com/support .
Significant changes since Build 18 v3.6.4 (Beta firmware release):
* Enhanced Color Matrix
* Decreased noise in blue channel, especially under tungsten lighting
* Increased accuracy of skin tones on RED-EVF, RED-LCD, and HD-SDI monitor outputs
* 48V Phantom Power is now maintained over power cycle (Rev B audio boards only)
* Headphone output level now maintained over power cycle.
* Fixed ""audio codec error" on clips with audio played back from RED-DRIVE
* Fixed "green flash" on clips with audio played back from RED-DRIVE
* Fixed camera reboot on clips played back from RED-DRIVE
* Fixed camera reboot following receipt of corrupted lens data from S4/i port.
Note: If camera encounters corrupted lens data it will disable S4/i port until next power cycle.
Note: Cooke S4/i lenses and Birger Engineering interface are not supported under this Build.
Thanks, BC
Significant changes since Build 18 v3.6.4 (Beta firmware release):
* Enhanced Color Matrix
* Decreased noise in blue channel, especially under tungsten lighting
* Increased accuracy of skin tones on RED-EVF, RED-LCD, and HD-SDI monitor outputs
* 48V Phantom Power is now maintained over power cycle (Rev B audio boards only)
* Headphone output level now maintained over power cycle.
* Fixed ""audio codec error" on clips with audio played back from RED-DRIVE
* Fixed "green flash" on clips with audio played back from RED-DRIVE
* Fixed camera reboot on clips played back from RED-DRIVE
* Fixed camera reboot following receipt of corrupted lens data from S4/i port.
Note: If camera encounters corrupted lens data it will disable S4/i port until next power cycle.
Note: Cooke S4/i lenses and Birger Engineering interface are not supported under this Build.
Thanks, BC