View Full Version : Build 20 = higher frame rates?
Ramesh Jai
07-31-2009, 03:04 AM
Before yesterday I couldn't get more than 30fps in Varispeed mode configured at 3K 16:9 under build 18, 17, etc.
Yesterday after changing to the latest build, 20.1.2, all of a sudden I had access to more than 30fps, infact I could crank it up to 50fps. Momentary insanity or was this feature always there and I didn't know how to access it?:blush5:
Either way, I'm happy.:nopity:
Brandon Fraley
07-31-2009, 03:08 AM
pretty sure it was always there :)
BillBarnes
07-31-2009, 03:09 AM
From Red.com, the camera "provides 4K (up to 30 fps), 3K (up to 60 fps) and 2K (up to 120 fps) capture."
J. Eric Camp
07-31-2009, 07:32 AM
Always like this
Raphael Varandas
07-31-2009, 08:20 AM
Yeap always like this to me too...
Regards
Maxim Penev
08-05-2009, 03:46 AM
I had the same bug.Build17, 8gb CF, 3k, 16/9, 35fps and as soon as i pressed the rec key "Frame rate too hi".After a reboot everything get normal again.
Johan Malmsten
08-05-2009, 05:06 AM
What speeds do your cards provide? I seem to remember that the Red is quite demanding on IO-speeds of the CF-cards... so maybe the framerate is capped by the card and not by the camera or its firmware build?
Dominic Jones
08-05-2009, 05:53 AM
Were you shooting 29.97? If so, you most likely had "open gate" enabled in the VF settings - that will limit your framerate options in varispeed...
Just a thought,
Dom.