FCP XML problems

[N_Villers]

Hi -I first want to say how much great promise there is for this software. Keep going with the hard work.

Hope this is not a reposted bug.

I am experimenting with importing a FCP XML. In my original attempt there was mixed 16:9 and 2:1 material but after frequent crashes would appear after relinking only on the timeline (small icons) but not on the image viewer.

I then reduced the xml down to a 3 clip edit of 2:1 RC28. I can import, reconnect and get it to play normally but when I try enabling the RRcard monitor out I find the image via hd-sdi completely mismatched (ie. slate showing) to the UI monitor. After turning it off again I cannot get it to turn back on without restarting.

After many crashes I experimented by manually importing and editing the same clips and it seems to have the same mismatch between UI monitor image and RRcard enabled HD-sdi out.

My system --> MacPro 3.1 2.8ghz 8core 12GB ram +650MB/sec RAID5 RRcard->hd-sdi->tvlogic24"

-noel

[Dan A]

Hi -I first want to say how much great promise there is for this software. Keep going with the hard work.

Hi Noel, thanks for the positive comments!



...after relinking only on the timeline (small icons) but not on the image viewer.

This sounds like an issue we hope to resolve very soon. There's an issue with Storm not recognising RedColor2 so it just display black in the viewer.



I then reduced the xml down to a 3 clip edit of 2:1 RC28. I can import, reconnect and get it to play normally but when I try enabling the RRcard monitor out I find the image via hd-sdi completely mismatched (ie. slate showing) to the UI monitor. After turning it off again I cannot get it to turn back on without restarting.

After many crashes I experimented by manually importing and editing the same clips and it seems to have the same mismatch between UI monitor image and RRcard enabled HD-sdi out.

I have seen the delay on the external monitor. I will check but I think it might be tied in with the SDK. I'll log it for further investigation.


many thanks,
Dan

[N_Villers]

This sounds like an issue we hope to resolve very soon. There's an issue with Storm not recognising RedColor2 so it just display black in the viewer.

Great!


I have seen the delay on the external monitor. I will check but I think it might be tied in with the SDK. I'll log it for further investigation.
Dan

It is not only lag that I'm witnessing but the hd-sdi is displaying an image outside of the in/out edit.

[N_Villers]

I'm still seeing this bug in the new build.