Settings for 4:4:4 3 Gb/s Single Link SDI output

[Andrae Palmer]

I've got the Decklink Extreme 3D+... in settings do both:

1. Use 4:4:4 SDI on video output when possible
2. Use 3 Gb/s Single Link SDI not Dual Link SDI output

have to be checked?

I'm using Blackmagic Design Desktop Video 8.0 and sometimes not getting a feed into the FSI LM-2461W monitor. With the FSI LM-2461W how do you verify that you're getting a 3 Gb/s signal? With #1 unchecked I'm getting a video feed. Just don't know if it's a 3Gb/s feed.

http://farm6.static.flickr.com/5027/5695714804_aa8dbdc8f4_o.png

http://farm6.static.flickr.com/5262/5695731540_99d4694181_o.png

When I quit Davinci Resolve and reload with the same settings as above, noticing that the monitor is not receiving a signal. I have to go back into BM Desktops settings and uncheck #2 and then recheck it for the feed to appear.

[Andrae Palmer]

Stream1:
http://farm6.static.flickr.com/5061/5696104321_1d9c5fd6b5_z.jpg

Stream2:
http://farm4.static.flickr.com/3589/5696096217_e745b87c45_z.jpg

PAP:
http://farm3.static.flickr.com/2780/5696097169_034079e15c_z.jpg

With the above settings show in post 1 the monitor is believing that the signal is a 3G Level B muxed signal. How do I get the monitor to show a 3G level A signal? Flanders Scientific believes the problem is with the card.

[Andrae Palmer]

Anyone know why the BM Decklink Extreme 3D+ would not be outputting 4:4:4 RGB? According to Dan Desmet at FSI this is looking like it's exporting 4:4:4 YCbCr. Unfortunately BM support is closed for the weekend.