Stacey Spears
11-18-2007, 06:46 PM
Time code burn-in falls off screen when you toggle name.
To Repro:
1. Under Project Settings, on Project page, select New
2. Under Import, on Project page, select "Load Shot...", pick and R3D file (I am using A003_C007_071105_001.R3D) and select Open
3. Under Format Settings, on Project page, change format to "Film 1K"
4. Switch to Shot Page
5. Under Shot Framing, on Shot page, click on "No scaling" button and select "Fit Width"
6. Switch to Output Page
7. Under Burn-in, on Output Page, click on "Add: Nothing" and select "Frames/S-TC".
You should see something like the attached image. (01_Initial.jpg) Notice that the 01 is missing at the very end of the file name.
8. Under Burn-in, on Output Page, click on "Name" to deselect.
You will now see something like the attached image. (02_without_Name.jpg) Where is my time code?
9. Under Burn-in, on Output Page, click on "Name" to select.
You will now see something like the attached image. (03_with_Name.jpg) Where is my time code? The name is back, but now I am missing 001 at the end.
Expected Results:
I would expect that if I deselect name that the time code remains. I also expect that full name (ie 001 at the end)
Actual Results:
Missing end of file name. Toggling the name button results in the time code missing.
To Repro:
1. Under Project Settings, on Project page, select New
2. Under Import, on Project page, select "Load Shot...", pick and R3D file (I am using A003_C007_071105_001.R3D) and select Open
3. Under Format Settings, on Project page, change format to "Film 1K"
4. Switch to Shot Page
5. Under Shot Framing, on Shot page, click on "No scaling" button and select "Fit Width"
6. Switch to Output Page
7. Under Burn-in, on Output Page, click on "Add: Nothing" and select "Frames/S-TC".
You should see something like the attached image. (01_Initial.jpg) Notice that the 01 is missing at the very end of the file name.
8. Under Burn-in, on Output Page, click on "Name" to deselect.
You will now see something like the attached image. (02_without_Name.jpg) Where is my time code?
9. Under Burn-in, on Output Page, click on "Name" to select.
You will now see something like the attached image. (03_with_Name.jpg) Where is my time code? The name is back, but now I am missing 001 at the end.
Expected Results:
I would expect that if I deselect name that the time code remains. I also expect that full name (ie 001 at the end)
Actual Results:
Missing end of file name. Toggling the name button results in the time code missing.