system freeze when copying R3D from RED DRIVE

[Antoine Baumann]

I am experimenting system freeze when I copy R3D files from a RED Drive to a ntfs formated hard drive. No problem when I copy the same files to a fat32 formated hard drive on the same system and no problem when copying R3D files from a CF card to the same ntsf formated drive.
It seems to me that the RED drive doesn't like to copy its files to a ntsf formated drive....seems strange but that's what I'm experimenting.

I am running xp64, SP1

Thanks for help.

ciao,
antoine.

[Adrian T.]

How should the RED drive notice where its data is going? It's just delivering the requested data. If you have problems writing it on a certain drive it's most likely a problem with that specific drive - or the OS/drivers.

[Antoine Baumann]

thanks for the input, I will perform further testing.

antoine

[Antoine Baumann]

SORRY for the report problem, as it has nothing to do with the RED drive.

antoine.

[Adrian T.]

SORRY for the report problem, as it has nothing to do with the RED drive.

antoine.

Told you so. :sarcasm:

Mind if you tell us what it was?

[Antoine Baumann]

Well, I've successfully copied the content of a RED RAID to a ntfs formated single hard drive, but still I'm not able to copy it to a CALDIGIT 2 bay raid in mode raid 0. I have this CALDIGIT since months, and had no problem at all with it, never had to install any driver for it...

I will try this CALDIGIT on xp32 bit to see it I have more success. Will report on it.

ciao,
antoine.

[Patrick Tresch]

Hello Antoine,

Here a low low light test of this week end. I kind of like this picture even if it seams slight out of focus. My assist. was 5 cm off:biggrin:

Have a nice week. It was fun to do these "test" with you.

Patrick