Search:

Type: Posts; User: Mike P.

Page 1 of 10 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    3
    Views
    207

    I was under the impression that the goalpost...

    I was under the impression that the goalpost (left side noise bar) should *not* change when the metadata settings are played with (ISO, FLUT, Brightness, gamma, etc.)

    Also your pictures didn't...
  2. Replies
    9
    Views
    423

    I have only used an FS700 twice (without 7Q,...

    I have only used an FS700 twice (without 7Q, though I have used one of those connected to a vanilla Alexa instead of a codex); in terms of "clunky" design, I'd say DSMC is just as clunky. No XLRs,...
  3. Replies
    154
    Views
    11,703

    I would add built-in v-mount/ab plate that sends...

    I would add built-in v-mount/ab plate that sends power through the brain (no cables)... And integrated shoulder pad/arch... AND KNOBS for those XLR ports (going through the menus to adjust pre-amps...
  4. Replies
    10
    Views
    334

    I do it in post too, especially if you're rocking...

    I do it in post too, especially if you're rocking dragon/6k... Other than that, as Bob said, the Helix's pivoting is based off of the optical centre so it should work too (though I'm not sure if it...
  5. Replies
    25
    Views
    350

    Thanks for your input Marc. I do...

    Thanks for your input Marc. I do understand/appreciate using easier-to-use files solely for editorial. I was honestly just a little concerned that there was some other reason I wasn't considering....
  6. Replies
    3
    Views
    260

    [FS: GEAR] RedUser NormLi might have the lenses you're...

    RedUser NormLi might have the lenses you're looking for. And RedUser Lori Carlson might have the Alexas... I *think*... I've never purchased from either though, I've just seen their posts.
  7. Replies
    10
    Views
    387

    I think this is Dragon only. Or at least RED...

    I think this is Dragon only. Or at least RED claimed it was (otherwise, even Scarlet-X would have ANA modes, as we'd just window/crop it manually).
  8. Thread: DSMC Functions

    by Mike P.
    Replies
    11
    Views
    426

    Those switches can be remapped to do functions,...

    Those switches can be remapped to do functions, but for all intents and purposes, using a button to take a single-frame (ala a traditional stills mode) has been aborted.

    Instead, you're supposed...
  9. Replies
    25
    Views
    350

    The only reason I don't like converting is...

    The only reason I don't like converting is because it essentially doubles your data/storage requirements, and doesn't give you any benefits other than speed. And with a decent computer and...
  10. More important than the actual computer (truth be...

    More important than the actual computer (truth be told, you can rip through 6k in Premiere on even a 1st-gen MBPr when you preview at 1/4res), is the storage size/speed and corresponding network...
  11. Replies
    25
    Views
    350

    Or at least send reference audio... Honestly the...

    Or at least send reference audio... Honestly the process (in FCPX anyway) is not difficult and it's quite fast (and background tasked for the most part). The problem is that it can get pretty...
  12. Replies
    53
    Views
    3,323

    Yes, potentially more, since it clips much...

    Yes, potentially more, since it clips much quicker than Dragon and the halation can mask that quite a bit... That said, Epic-X doesn't have removable OLPF (though I didn't think anything is...
  13. Replies
    29
    Views
    4,072

    That's what it is with MX too. The problem is,...

    That's what it is with MX too. The problem is, with MX, you see a sharp falloff of highlight stops when you go down to ~320 (hell, you even see a sharp falloff of highs at 800ISO too)... That is to...
  14. Replies
    7
    Views
    571

    Start a support ticket and talk to your bomb...

    Start a support ticket and talk to your bomb squad rep. You can try re-installing the firmware, but this looks like it'll need to get shipped back to RED.
  15. Replies
    14
    Views
    1,000

    I use RG4 hard (on MX) and then use the "shadow"...

    I use RG4 hard (on MX) and then use the "shadow" settings to dig out crushed-ness to taste. I'm please with it, as it tends to put everything else (mids/highs) in the right spot by default and the...
  16. Replies
    18
    Views
    1,045

    I was under the impression that modules were...

    I was under the impression that modules were proprietary, so no one else was allowed to make them without getting sued by RED. DSMC would have been a hell of a lot different had it been opened up...
  17. Replies
    18
    Views
    1,045

    You should also be able to feel air being pushed...

    You should also be able to feel air being pushed through the ProIO (out the top vent). It's very faint (because the grills are horrible restrictive), but you can feel it. Honestly, you'll know if...
  18. I'm sorry; so does that mean the FAA and the AOPA...

    I'm sorry; so does that mean the FAA and the AOPA are also going to control birds and put stipulations/regulations on how they fly? If they're not, then this is a tad hypocritical... And trust me,...
  19. Thread: Audio sync

    by Mike P.
    Replies
    12
    Views
    425

    Definitely do both TC and scratch track. That...

    Definitely do both TC and scratch track. That way, worst case you can use an "audio sync program" like plural eyes if poop hits the oscillator... And if that fails, the slate (which can be dummy,...
  20. Ha! It adds a touch of class to any parcel.

    Ha! It adds a touch of class to any parcel.
  21. This will actually give you a cleaner image, as...

    This will actually give you a cleaner image, as it isn't needlessly being set to ISO800 (even on shots/scenes that didn't need it)... Conversely, it's the same as if s/he left the footage shot at...
  22. Replies
    18
    Views
    1,045

    Holy schnikies... I thought I was the only one;...

    Holy schnikies... I thought I was the only one; an outlier. I hope it doesn't happen again as ~$400 for a replacement fan on an already exorbitantly expensive $3750 part is a little... Excessive (to...
  23. OCD is going to get the better of you, and you'll...

    OCD is going to get the better of you, and you'll have to get the rest of the set rehoused to match... ugh...
  24. Replies
    6
    Views
    283

    [(RED) WTB] Bumpkin... And I'm actually looking for an 18"...

    Bumpkin... And I'm actually looking for an 18" right-to-right.
  25. Replies
    93
    Views
    14,010

    Anyone found any inexpensive 95Wh Beillen-style...

    Anyone found any inexpensive 95Wh Beillen-style v-mounts (that come with charger) on eBay?
Results 1 to 25 of 250
Page 1 of 10 1 2 3 4