I doubt very much You could tell which scenes in Finshers' Dragon tattoo were shot with the R1 and which with the Epic. I have a side by side in front of me
and not until a 400% enlargement can one...
Type: Posts; User: Rolf Kestermann
I doubt very much You could tell which scenes in Finshers' Dragon tattoo were shot with the R1 and which with the Epic. I have a side by side in front of me
and not until a 400% enlargement can one...
I completely agree. I mentioned it in a different thread, but man was I happy when the BT R1 became available. Its quiet, runs the bomb evf without flicker
and the 7inch LCD with less banding...
I don't think its an IR problem if You are using a superspeed 18mm. Its a very pronounced effect with the wide angles of that group since they were not designed having a flat glass in the path to the...
I totally agree, actually I bought the BT version when it became available, after I went through the stage 3 upgrade. As a Cinema camera I consider it my A-Body and the Epic as the B-Body for Back...
Just chiming in, I do a lot of CA correction in post since I have a slew of old Angenieuxs, and actually enjoy turning these underdogs into great performers. I have found
occasional to scale the...
I have the the same issue with my Super speeds, especially the 18, 25 and 35.They will create a purple hot spot in the middle of the frame when closed down past about 5.6 with a bright surrounding...
Actually I own two, just to make sure to get the best out of them. They both behave very much the same, one having a slightly different coating than the other( B or T). Both are equiped with a...
There is a view to look at a lens, right through it at what matters.
One thing to consider in Your math is that Film is made of color layers and that the grain itself is composed different for each frame, which again moves within the gate for
each frame, and does so...
A 40 and a 65
Early Angies came that way, then You would add or change to a BNCR or Cameflex etc. I recently bought one and had Duclos changed it to PL
Don't replace an L for this! I owned it for a day, than returned it, badly made. Promising range, but....Replaced it with the Canon version, better, but after that I had it with still zooms for film.
I presume You mean the T3.9 25-250. I have two of them and just bought a BT R1 as it works well with it. To use 4.5K it will vignette below 30mm, but in a soft way, not a hard cut out.
Overall of...
Hi there, just had the camera up, the 7'' will give You the unsqueezed picture, but I don't know what the ratio of 4K ANA is.
I doubt You will see anymore R1s for sale, I just hope they will service them for some years to come (obsolescence obsolete ?). I think that the radical pricing policies are actually
designed to...
Go for dirt cheap any day, but the best choice in my opinion is to find 1st or 2nd generation Angenieux zooms with PL, Arri or M42 mount.
Like going from 5K to 4K
CA in general does not improve by stopping down the lens, the picture gets sharper because of a greater depth of field, higher contrast etc but the only way to avoid most of it is to use a smaller...
Cordvision, $59, all You need, maybe a tie down if Your lens goes on a remote head to look upside down. Well made, use it for 3 different zooms.
I looked at the lens a little more closely over the last couple of weeks and thought to share my observation. First off, for the money, it is a steal, but (there always is)watch out for expensive...
Such a bizarre comment. A lens is a tool and this is not only the first 10X Zoom on the block and very sharp at a decent stop, it is also the only one at 5.7 pounds You can hand hold without a...
The 18mm Zeiss Superspeed also covers full 5K.
I probably I gave the wrong impression, it is a sharp lens even full wide, lets just say it gets outrageously good at 85mm.
Just bought it last week after some hesitation. There seems to be always one more battle tested unit available, mine was brand new or appeared that way.
Assuming all units are like that, they are a...
My first reply here, apologize for technical errors, but yes, why are threads deleted, and by who? Have seen this at another software forum, why have a forum at all?