Search:

Swap out the philips locking screws for hex and you can use an Allen wrench at a right angle. Then you don't have to dismount the lens to lock it.

I am trying to locate some PL mount screws. It's T20 drive M4. Not sure if this is made by Red or not. A published list of McMaster part numbers would be very helpful!

Does anyone know if this problem is resolved with build 3.0.5 beta?

Upgraded to build 3.0.0 on our Epic 3D rig. Set monitor output to 720p (so we can view in 3D mode on Panasonic BT-LH910). Sync light turns red! Sync light is green when output is set to 1080p.

We...

We have found the old SB-T and the new upgraded one to both work the same. Are we just getting lucky with the old one? Trying to decide if we should upgrade all units or keep going with what is...

I haven't seen two Epics match. It's all metadata, so I suppose it doesn't matter, but the images on the touch screens are usually different from camera to camera.

I would like to know the answer as well!

Question: Does playback work with 3D, with the Master/Slave cable allowing synced playback on both cameras?

If so, you have made my day. No, my month!

JP Perry

I experienced the same ROCKETIO ERROR that others have reported. I noticed it only happens when the camera is cold, ie the first boot in the morning and/or when the temperature was less than 55 deg...