A Lot of Noise in My Rendered QTs

[IanK]

When I export QTs from Red Alert I am getting a lot of noise. I have tried adjusting settings to work around it but I cannot fix it. I have tested different Denoise, Debayer, and OLPF settings but nothing seems to fix it. Does anyone have any ideas?








Ian

[Clint Johnson]

On the "Output" section have you set the Process to Full?

Then I would start moving the Quality settings up from Normal > High > Maximum > Lossless until it smooths out.

How about the specific codec inside the Quicktime? Using H.264 is a relatively safe bet but you might want to try JPEG 2000 as well.

[Uli Plank]

This doesn't look like noise, but like banding. What codec are you using in QuickTime?

Regards,

Uli