Thread: Help! Smallhd 702 “no signal” when plugged into dmsc2 I/o

Reply to Thread
Results 1 to 4 of 4
  1. #1 Help! Smallhd 702 “no signal” when plugged into dmsc2 I/o 
    Senior Member
    Join Date
    Feb 2013
    Posts
    194
    Help! Smallhd 702 “no signal” when plugged into dmsc2 I/o
    Tried it with another monitor , also no signal.
    Tried monitor on another hdmi device, works fine.
    Either the hdmi port on my I/o went bad or I’m missing a setting to make it compatible , it’s worked in the past. Any ideas
    Reply With Quote  
     

  2. #2  
    Senior Member Tom Van's Avatar
    Join Date
    Feb 2012
    Location
    Hollywood, FL
    Posts
    604
    Not sure if this is the issue but the side pogo of the DSMC2 body shares the same port as the SDI port. So if you have a RED LCD monitor mounted on the side, the SDI won't work.
    _____________________________

    Tom Van

    Epic-X and Epic-W
    www.motionhaute.com
    Reply With Quote  
     

  3. #3  
    Senior Member Tom Van's Avatar
    Join Date
    Feb 2012
    Location
    Hollywood, FL
    Posts
    604
    Not 100%, but HDMI applies as well.
    _____________________________

    Tom Van

    Epic-X and Epic-W
    www.motionhaute.com
    Reply With Quote  
     

  4. #4  
    Member
    Join Date
    Aug 2017
    Location
    Sweden
    Posts
    31
    Try a hardware restore, hardware rediscover?
    Reply With Quote  
     

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts