Looking for a high quality articulating arm for my monotor.

[adam brennan]

I am looking for a good quality articulating arm for my monstro/monitor. I am using the Red version, but I am sure that one is a rebranded one from China. It works but think it will wear out and doesn't hold up to well without cranking down on the lever.

[David J. Buchanan]

Titan Arm is the best I've used.

[adam brennan]

I was looking at that one. But the elbow on the arm doesn't look like it allows much movement since it's not a ball joint? It looks huge too. Is it heavy?

[Chris Kennedy]

Titan is solid and once unlocked the movement is fluid.
I also have a couple Noga arms and they are alright-but not as solid as the Titan.

[Uros Zuraj]

SmallRig arms, you can make them short or long as you like and with different screws,... on each side

[Mike Kozlenko]

Matthews Infinity arm is my favorite and the most rugged and reliable I've used, by a mile, even over the Titan arm. Not sure if Matthews still makes them anymore though

[FrankMcPartland]

I use an "early model" Matthew Infinity Arm ---very solid...

[Nick Gardner]

They all kind of suck and fail eventually. I find the small rig arms the most cost efficient ones. They have rosettes at the main joint, so they don't slip very much.

Nick

[Bobby Farokhzad]

I used almost every single arm out there... the Titan arm is head and shoulders above the rest. It is heavier than most arms but it will outlast your career.

[Johnny Hurberg]

Infinity arm, can be used as a handle as well.