Thread: Any dumb EF mount 3d printing models out there?

Reply to Thread
Results 1 to 3 of 3
  1. #1 Any dumb EF mount 3d printing models out there? 
    Senior Member Samir Patel's Avatar
    Join Date
    Jul 2012
    Location
    Miami, Florida
    Posts
    1,974
    Any dumb EF mount 3d printing models out there? Figure I can ask a friend of mine to print one out for me to throw on an old Scarlet-MX I barely use using a fixed contax 50/1.4 lens... No point spending $600+ for an electronic one.
    Reply With Quote  
     

  2. #2  
    Senior Member Karim D. Ghantous's Avatar
    Join Date
    Oct 2011
    Location
    Melbourne AU
    Posts
    1,906
    Have a look at this:

    https://grabcad.com/library/red-dsmc-pl-mount-1#!

    You can extract the base and then fuse it to an EF mount from here (for example):

    https://www.thingiverse.com/thing:958698

    You would need to do some arithmetic to figure out flange distance but that shouldn't be too hard.

    We use 3D printers where I work but I'm not on that project. I might give it a shot, though, some day.
    Good production values may not be noticed. Bad production values will be.
    Pinterest
    | Flickr | Instagram | 1961 (blog)
    Reply With Quote  
     

  3. #3  
    Senior Member Samir Patel's Avatar
    Join Date
    Jul 2012
    Location
    Miami, Florida
    Posts
    1,974
    Thank you Karim
    Reply With Quote  
     

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts