744T and Red One FW 17

[blob]

Hello

First I would like to say hello. it´s my 1st post.

I was reading here about issues between the 744T and red one TC. Did the new Firmware update solve it?.
We´ve got a project and will be using the 744t on the set, and I´d like to inform the DOP and the producer about possible drift.

Thank you very much

regards

[Mark L. Pederson]

Hello

First I would like to say hello. it´s my 1st post.

I was reading here about issues between the 744T and red one TC. Did the new Firmware update solve it?.
We´ve got a project and will be using the 744t on the set, and I´d like to inform the DOP and the producer about possible drift.

Thank you very much

regards

Welcome blob -

We did extensive sync tests on Build 16 - and you can safely tell producer he/she has nothing to worry about.

[blob]

Hi Offhollywood

Thats great news
Thank you for reply

regards

[Dexter Gregoire]

Just watch your sync after any Playbacks. Menu option 51 on the Sound Device.

I also use the 744T to RED.

[blob]

Thanks Dexter.

Just to clear one more thing: in which mode of the timecode do I have to work?
Free run, 24, . I´m a bit a noob :sick:

Thank you in advance
regards

[Morten Eriksen]

...in build 16 you should put th camera in record when you jam sync RED and 744T right?

[Dexter Gregoire]

...in build 16 you should put th camera in record when you jam sync RED and 744T right?

That's one way.

One other way is to use the RED camera menu function Jam Sync.

[Dexter Gregoire]

Thanks Dexter.

Just to clear one more thing: in which mode of the timecode do I have to work?
Free run, 24, . I´m a bit a noob :sick:

Thank you in advance
regards

Timecode framerate should match RED framerate.
For Timecode Mode I use Free Run.

If you're not sure what each Mode does and you already own a Sound Devices Recorder just call their toll free technical support. They are so helpful.

[Morten Eriksen]

Hi Dexter could you explain?

As far as I'm told from other threads I have to do like this:

1) Turn on jam sync in the menu
2) Put the camera in record
3) Connect the 744T with the LEMO connector to RED so the camera can sync

I have tried this without camera in record and it seems to work fine. But I'm told that timecode will drift to much if the camera is not in record??
Do you know anything about this??

Thanks

Morten

[Dexter Gregoire]

I notice NO drifting, ever.

Timecode framerate should match RED framerate.

1) Turn on jam sync in the RED Camera menu
2) Connect the 744T with the LEMO connector to RED so the camera can sync
3) Put the camera in record

That's one way that works.
4) Pay attention to Menu option 51 on the SD 744T. (When camera and recorder are in sync the numbers match). (RX - TC), (TX - TC) numbers should match.