I shot approximately 160 gigs on a 320 gig red drive.
Transferring to two G Raids via E sata (firmtek express card 34 card) through 1st generation MBpro. Red Drive is plugged in via FW 400.
I start xfer to one GRaid. 14 gigs into the transfer, my computer says a drive has been removed. Apparently, the G Raid I was xferring to lost connection. I power everything down, dismount all drives, reconnect everything, boot up and all drives appear.
But my RED drive says: 0 items. 141 gigs available. Nothing in the icon dock. Yet it shows 180 gigs have been used. So I'm assuming the data's still there.
The night before, I checked to see the first and last take on camera and the camera said 57% used. When I started the transfer this morning, everything was there until I re-booted. I've since checked it on two other computers - same thing.
Anyone have any ideas what to do.
As this has an important client's footage on this, time is of the essence. Please call me at 917 674-7861 or email me at: cinetim@mac.com
Thanks



