a bit of change...
TP2 ver 1.26
*skip missing clips
*skip nesting sequences
What is the procedure to tell the software where the folders are located, when you have the R3Ds in multiple drives or directories?
When I try to use the Re-Link procedure, I get reported 92 problems out of 103 clips!!!
When I created the LUA with TP2, it moved all fine to RCX. However, I always export with the RCX option of rendering on separate folders per clip. This will add the suffix of SXXX to any subsequent clips from the same shot.
Any problem with this procedure? See attached report:
Last edited by Luis Otero; 08-07-2010 at 05:51 PM. Reason: Add attachment
|« Previous Thread | Next Thread »|