Clip viewable on camera, but PC won't copy it and Mac wont recognize drive

[Eli Arenson]

Shooting with new mysterium-x chip, build 30.5.

Out of around 40 clips, only one of them won't transfer to PC. When i copy the file it begins to transfer but when it reaches around 100mb left, the transfer gets stuck.
On the camera the file is viewable from start to finish without a hitch. on RedCine the clip is viewable from start to ..err.. middle.
PC recognizes the harddrive fine - MAC doesn't.

The mag was mixed with multiple 4k and 2k shots. I was warned long ago never to mix 2k and 4k clips on the same mag, but since build 21 when i heard that the myth was shattered i started ignoring this warning and never ran into any problems since.
could it be that build 30 has this problem again? This is just an assumption...

anyone run into this problem before?

[Giac]

I had a problem like this few weeks ago, while shooting with build 30.5 (not m-x, but the old sensor). when I tried to transfer one of the 20 clips I've shot, before reaching the middle of the transfer it got stuck. opening it with redcine it gave me the same problem as you, but in my case I couldn't see it on camera...
I tried to send the mag to the lab, but they sent it back saying they couldn't do anything...
the only hope is that your file at least is viewable on camera, maybe someone of the red assistance knows a way to transfer it.