Untethered flight! Phil demonstrates SteadiRED

[Jason Goodman]

This iPhone video clip shows Steadicam operator Phil Martinez flying dual MX sensor RED ONE cameras on a 21st Century 3D BX3 beamsplitter with two Angenieux Optimo Rouge 16 - 42mm lenses. The cameras and Transvideo 3DView monitor are powered directly off the Steadicam sled. This is an awesome demonstration of a floating, untethered stereoscopic 3D mirror rig.

In an initial test about two weeks ago, we included C-Motion lens control gear. Phil was able to balance and walk around with the rig, but was disappointed that it maxed out his G70 arm. At the suggestion of a contact at Tiffen, Phil added additional tension to the arm with bungee cord. The added spring of the bungee was enough to make BX3 float.

The C-Motion gear was out on rental when we did the test shown in the video, but Phil was delighted with the results of the bungee enhanced arm and was confident that the small amount of additional weight from the motors and C-motion gear would not hamper flight.

[Adam Eden]

Phil wont ever need to go to the gym again!!

That's crazy!!! But I have seen 2 x SONY PDW-F800's on a steadicam rig!!

Bring on SCARLET!!

[Peter Matthes]

The sunglasses are the best part.

[Mark Toia]

Man! that must way a ton!
The old RED ONE isn't that light, 2 of them plus the stedicam rig and the splitter box.. cripes.

You win big man, Great work!

I bet you cant wait to EPIC that little rig.

[ericyoung]

Couldn't see the bungee cords initially - but saw them now wrapped around the bones of the arm. Any chance of a better picture of those, and how did you secure them - were they literally bungees with hooks on the end?

[Shane Betts]

Superman lives!

[constantine Tirintzis]

Eric hello just a pop in to comment about the bungie addition.
There is a much better way of doing this. What you will have to do is take one allen screw of each trunion on the left and right side of the arm diagonically and replace it wit anoher longer and if possible bigger head screw. Then you just get rubber bands and put as many as you like placing them diagonially parraller to the spring fro screw to screw. You can get rubber bands that are quite tough and add as many to serve your added weight.
But always remember to not overdo it.
Best

[Jason Goodman]

Constantine,

the method Phil used was recommended by Tiffen and it worked perfectly. Thank you for that input, but in this case, it ain't broke, so we aren't fixing it.

[Jason Goodman]

Eric,

I will need to ask Phil for a better picture of the bungees. As far as I know, he just straight up tied them around. No hooks involved. It was easy, involved no additional screws and took about 3 seconds to put on or take off.

[Philippe Van Horebeek]

Great job, but it's certainly not good for doing a whole day. :)