Thread: Important LTO-5 Media Warning

Reply to Thread
Page 1 of 2 12 LastLast
Results 1 to 10 of 12
  1. #1 Important LTO-5 Media Warning 
    Senior Member Tim Jones's Avatar
    Join Date
    Dec 2008
    Location
    Scottsdale, AZ, USA
    Posts
    275
    Hi Folks,

    I've been working through some serious drive failure problems with a couple of large clients and we've uncovered a very bad thing WRT LTO-5 media and archiving operations. If you use LTO-5 for archival (LTFS or normal data, regardless of platform of drive manufacturer), please read the following statement and ask questions here.
    An important discovery concerning LTO-5 media has come to light over the past few weeks. In cooperation with HP's tape engineering labs, we've discovered that some brands of recently available LTO-5 media are too rough and can cause undue head wear; specifically when used for archival tasks where a new tape is used for each job - meaning that each job gets a brand new tape instead of backup scenarios where tapes are regularly reused and overwritten. We've worked with HP, and through them, the major media vendors and a new formulation has been produced that reduces this issue to inconsequential. The new formulation is much smoother in the case of a new tape and head wear is greatly reduced providing the more expected life cycle of the drives when the drives are used in an archival environment.

    It is important that you consider any non-HP or Fujifilm branded media as potentially harmful when used in an archival environment and you should consider replacing any other media with HP or Fujifilm branded media immediately. While the other brands are safe for normal backup rotation utilization, they should not be used for archival operations as described above.

    With the formulation changes made and the effort that HP has put into a proper resolution, we have switched to HP-branded media as our stocked brand of LTO-4 and LTO-5 media. While we still support and recommend Fujifilm LTO-5 media, our partnership with HP through this has proven very important in insuring that our customers are getting the best solution available for backup and archival use.

    Indications of this problem to watch for include drives that start running more slowly on the same type and amount of data and situations where you get less than the rated capacity of a tape. Both of these can be indicative of a high/increased bit error rate (BER). If you suspect you are witnessing this type of issue, if you have an HP drive, you can test the drive using HP'S L&TT utility's "Drive Assessment Test".

    Hopefully, you haven't been bitten by this excessive head wear issue and will be able to adjust your media purchases to protect both your drives and your data. Most of the manufacturers consider this type of damage to fall outside of normal use and will not honor your drive warranty in this situation.

    Tim
    Tim Jones
    brumeister - www.productionbackup.com
    Reply With Quote  
     

  2. #2  
    Senior Member
    Join Date
    Nov 2007
    Posts
    311
    Hi there Tim,

    THanks for the heads up, with the HP media, is only there new media good, or did HP media never have a problem, only other brands? If Hp did have a problem at what date is there media good from?

    Thanks
    Reply With Quote  
     

  3. #3  
    Senior Member
    Join Date
    Nov 2007
    Posts
    311
    One more question regarding HP tape and tape machines, have you seen this article about HP exiting the PC business, will this effect there lto machines.

    http://money.cnn.com/2011/08/18/tech....htm?hpt=hp_t2
    Reply With Quote  
     

  4. #4  
    Senior Member Tim Jones's Avatar
    Join Date
    Dec 2008
    Location
    Scottsdale, AZ, USA
    Posts
    275
    We have it on very good authority that the changes don't affect the storage divisions. Tape and disk storage are considered "enterprise" segments and the change is designed to make that segment of their business stronger.
    Tim Jones
    brumeister - www.productionbackup.com
    Reply With Quote  
     

  5. #5  
    Senior Member Tim Jones's Avatar
    Join Date
    Dec 2008
    Location
    Scottsdale, AZ, USA
    Posts
    275
    I'll need to check dates, but anything HP newer than July should be good. All of our stock media is the new formulation.
    Tim Jones
    brumeister - www.productionbackup.com
    Reply With Quote  
     

  6. #6  
    Senior Member
    Join Date
    Nov 2007
    Posts
    311
    THanks for your answers and time Tim.
    Reply With Quote  
     

  7. #7  
    MAJOR kudos for that info!
    Michael "Strawberry" Romano
    ICG Local 600 DIT | West Coast USA | Honolulu, Hawaii
    Mobile: 239-218-4452
    http://www.strawberrycolor.com/
    http://www.sightandsoundhawaii.com/
    Reply With Quote  
     

  8. #8  
    Is this problem related to LTO-5 media only ... or to LTO-5 drives in general?
    Are we safer if making LTO-4 tapes in a LTO-5 unit?

    My unit is IBM, but I think most units use the same hardware inside.

    Daniel Perez
    WhyOnSet Madrid
    Pre-POST, POST, DI & FILMOUT
    Reply With Quote  
     

  9. #9  
    Senior Member Adam Jeal's Avatar
    Join Date
    Dec 2006
    Location
    South-West Scotland
    Posts
    233
    Hi Tim,

    I've a few questions re; LTO-5. Is it true that the Freecom drives are re-badged HP units? I'm looking at the Freecom LTO FH 34380 SAS drive. Also, will there be SAS to Thunderbolt adapters made available soon and will we be able to use such a set-up with Bru PE?

    Thanks,

    Adam
    Adam Jeal
    Acoustic Space Productions Ltd
    www.acoustic-space.com
    www.static-film.com
    www.twitter.com/adamjeal
    Reply With Quote  
     

  10. #10  
    Senior Member Omar Al-Masab's Avatar
    Join Date
    Jan 2009
    Location
    Kuwait
    Posts
    159
    by the way, what do you guys recommend for a LTO system that is easy to use and works with the mac ?
    Reply With Quote  
     

Tags for this Thread

View Tag Cloud

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts