Hey there, I have an early R1 that has been upgraded to the MX chip. I bought it a few months back from a fellow reduser. I'm curious if anyone knows if the single "Click" noise I hear when I turn the red on is normal. It sounds like a power relay, however, the two other red's at my job don't make this noise. They are MUCH newer though.
When I press the power button, the back panel screen illuminates, I hear nothing for about 5-10 sec. Then I hear the click noise (relay I assume) immediately followed by "booting..." after another 60 seconds the camera boots up normally. That 5-10 seconds of nothing has me worried. Before I send it out to Red I was wondering if any of you had any thoughts. Have any of you experienced this? Is it normal?