Anyone have suggestions as to how I get out of this one.
I just upgraded my Epic-X to 3.0.6. The reason for this is that I just finished a long project where the camera stayed on 2.0.5 and I wanted to try out my Canon mount which has been sitting in a box for over four months.
The upgrade went fine and on reboot after fitting side handle and Canon Mount, I was able to use my Canon 16-35 fine. Shut the camera down and went to try with a battery in the side handle. On boot up the touch screen was blank. I reverted to mains and although I could hear the fans and the lens motors operate, no picture. I have tried with a second screen, still no picture; and even with the bomb EVF where I just see a chip chart.
There is obviously a firmware glitch and the firmware needs reloading. Is there any way to do a force upgrade now? The new system requires the camera to be up and running with the reload through the maintenance dialogue which needs a screen! Catch 22