David and Rob,
It wil lbe a few more weeks before I can swing the upgrade to CS-6, please forgive the following suggestions if they've already been addressed.
I'd like to start to use ChromaDuMonde charts on set, but looking at the post workflow options there does not seem to be a good method for getting vectorscope feedback while setting up the Source Settings.
One method would be to bounce in and out of the source settings window while referencing the editing window... which would get old quick. Another would be to connect an external vectorscope to a RedRocket card and use RedCine-X to save RMD files. Not optimum but more do-able.
Two features that would greatly help would be:
*Main: A radio button toggle on the source settings window that would flip between the current RGB parage and a vectorscope.
*Secondary: Activating the Monitor Out on the Red Rocket while the Source Setting panel is active (dependent on the Red APIs I'm sure...).
Using the R3D's source settings to normalize the images just makes too much sense to me. I hope you guys can provide some sort of software solution in this area.
Regards,
Bob
