Decoder settings

[Frank Martin]

Running 8.2.2. When I open source tab in config page and then open Red decoder settings I can't get them to change.,Is this enabled and if so is there a setting I'm not ticking? Thanks

[Dwaine Maggart]

You need to set "Decode Clips Using" to Project.

Dwaine

[Frank Martin]

Thanks Dwaine

[Frank Martin]

I can't seem to find " decode clips using" tab , where should I look. Thanks again.

[John Tissavary]

It's in the config page > source tab. Decode using project settings is one of the radio buttons near the top on the left side of that tab page.

JT

[Frank Martin]

Thanks John I appreciate the help