Just plugged a MicroForce controller into the GPIO port on my new Pro I/O module via a Preston Red-MF cable (the one that worked great on the Red One body) and immediately got a message which said in effect there was too much current coming out the port, and it seemed to go into a "safe mode" which was nice, rather than just blowing the fuse on the Microforce (or worse). Are Microforces suppose to be getting plugged into the AUX port? If so, I guess a whole generation of Preston cables for Red are obsolete.
Does anyone have any expertise on how to make this situation happy? I've dug into the GPIO menus a bit, but quite frankly they're a bit overwhelming.