Booted the camera with the 7” on. Got a message that the EVF/LCD Module needed updating or some such thing. Ran the update and the 7” no longer responded to touch. Rebooted the camera and, after the first part of the boot cycle, the PWR and REC lights started flashing green. Gave it a very long time because that usually indicates an update but the monitor never turned on and the lights never stopped blinking so I eventually turned it off. Does the same thing every time on boot, 7” doesn’t display anything. If I boot without the 7”, it boots normally but if I then put the 7” on the lights start flashing again and the monitor never turns on. SDI monitor gets picture but overlays are turned off so there’s no info.

Any thoughts? Seems like the EVF/LCD module may have been bricked by the damn update.