GYRO sensor calibration ... stuck.

[PatrickWebb]

Hey, I have been having a slight issue and after reading through the manual I have come to a little pothole in the road. I am trying to calibrate the sensors in the EPIC so I can work my camera for a 3D job coming up next month, but the calibration doesn't seems to want to finish. I have left the camera on for an hour or so, but still no luck. It just seems to have stuck itself on the calibration screen. I am glad I have started the prep now and not a day before the job!

So, I was wondering if anyone else have experienced such an issue with their cameras and if there is a way around it or a known issue? If not and it is one for the "too hard box" then I'll just rent another brain for the job.

Cheers!

 

[Mark A. Jaeger]

When you calibrate are you only trying "cold" when the camera is actually cold and hot when the camera is hot? I calibrated today and, as the camera was hot, the hot calibration went well (only taking a few seconds). When I selected the "cold" calibration the camera would not perform it.
Is your camera blocking your effort?

 

[PatrickWebb]

When you calibrate are you only trying "cold" when the camera is actually cold and hot when the camera is hot? I calibrated today and, as the camera was hot, the hot calibration went well (only taking a few seconds). When I selected the "cold" calibration the camera would not perform it.
Is your camera blocking your effort?

Good question! I am pretty certain I let the camera warm up to calibrate. However, because I'm uncertain, I will give it another whirl!
Thanks, Mark!

 

[PatrickWebb]

Update: I tried the calibration once again and it just stayed there on loop. I think there might be an issue there? Little frustrating.